Owner's Manual

Programmer
80
Chapter 2 Programming with Help Function
5
Ending program
1. Press
P
.
Canceling thread breakage at the last stitch
Addition of feed after the last point can cancel thread
breakage at the last stitch.
When "115" is input for the end code, the thread breakage does not occur. In this case, every thread breakage
including emergency stop is canceled. Carry out the following setting for canceling thread breakage at the speci-
fied point.
1
Programming
1. Create the program 1 stitch (A) before the
desired end point.
2. Press

ESCESC
.
The number of pressing varies depending on the programming
method.
3. Select with and press .
4. Move the work clamp with
for the
stitch length. Press when the needle
point is at point B of the pattern.
Point B is programmed.
5. Press

ESCESC
.
Stitch
length