Product Info
Table Of Contents
- 1 General Description
- 1-1 Block Diagram
- 1-2 Product Version
- 1-3 Specification
- 2 Electrical Characteristics
- 2-1. Absolute Maximum Ratings
- 2-2. Recommended Operating Range
- 3 Pin Definition
- 4 Mechanical Dimension
- 5 Recommended Reflow Profile
- 6 SiP Module Preparation
- Industry Canada statement
- This device is intended only for OEM integrators under the following conditions:
- Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes:
Trace antenna designs
See the documents: “GR0136_Antenna_2020_1130” & “Test Procedure of embedded Antenna for GR0136
GIOT module”
RF exposure considerations
20 cm separation distance and co-located issue shall be met as mentioned in “Summarize the specific
operational use conditions”.
Product manufacturer shall provide below text in end-product manual
“This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.”
Antennas
Brand name
Model name
Antenna type
Antenna gain
Antenna connector
Linx
ANT-2.4-USP
Mono-pole 3.8 (dBi) RSMA
Taiyo Yuden
AH 104F2450S1
Mono-pole (Inverted F) 1.9 (dBi) RSMA
Taoglas
GW.34.5153
Dipole 5.89 (dBi) RSMA
Ethertronics
1001013
PIFA / magnetic Dipole 2.6 (dBi) ---
Jesoncom
10I010D
Mono-pole 4.8 (dBi) RSMA
Label and Compliance Information
Product manufacturers need to provide a physical or e-label stating
“Contains FCC ID: 2AAS9-PICONODE” with finished product
Information on Test Modes and Additional Testing Requirements
EMC Certification Tools, Version: 1.6.14.1shall be used to set the module to transmit continuously.
Additional Testing, Part 15 Subpart B Disclaimer
The module is only FCC authorized for the specific rule parts listed on the grant, and that the host product
manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the
modular transmitter grant of certification. The final host product still requires Part 15 Subpart B compliance
testing with the modular transmitter installed.