Installation & Assembly

ManualsBrandsBrown Jordan Fires ManualsAll Outdoor Fireplaces & Fire PitsUrth Concrete Bio-ethanol Fuel Fire Pit

Clearances & Installation Manual

BIOETHANOL ONLY

Please read these instructions and the Burner Operations Manual provided with your burner completely

before operating the appliance. REFER TO THE OPERATIONS MANUAL IN THE BURNER PACKAGING

FOR CLEARANCE AND INSTALLATION INSTRUCTIONS IF USING PROPANE OR NATURAL GAS.

LUMEN

16.9lbs / 7.7kg

URTH

89lbs / 40.4kg

! WARNINGS:

IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION

MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.

e-NRG is the ONLY fuel to

be used in this appliance.

www.e-nrg.com

www.e-nrg.com.au

QUAD

219.9lbs / 99.9kg

MESA

153.6lbs / 69.8kg

LOOP

210lbs / 95.4kg

ARROYO

134.4lbs / 61.1kg

RISE

93.4lbs / 42.4kg

STRATA

90.1lbs / 40.9kg

EQUINOX

156.1lbs / 70.9kg

FLO

199.3lbs / 90.6kg

SOLSTICE

107.7lbs / 48.9kg

KOVE

141.8lbs / 64.4kg

Summary of content (4 pages)

PAGE 1
Clearances & Installation Manual BIOETHANOL ONLY e-NRG is the ONLY fuel to be used in this appliance. www.e-nrg.com www.e-nrg.com.au Please read these instructions and the Burner Operations Manual provided with your burner completely before operating the appliance. REFER TO THE OPERATIONS MANUAL IN THE BURNER PACKAGING FOR CLEARANCE AND INSTALLATION INSTRUCTIONS IF USING PROPANE OR NATURAL GAS. ARROYO LUMEN RISE URTH EQUINOX FLO SOLSTICE QUAD LOOP STRATA KOVE MESA 134.4lbs / 61.1kg 156.
PAGE 2
Clearances Installation When using Bioethanol as a fuel source this model is suitable for indoor and outdoor use. EQUINOX, RISE, URTH, STRATA, QUAD, LOOP TABLE, SOLSTICE, KOVE Before installation ensure that the model is positioned in accordance with the compulsory minimum clearances outlined below. WARNING: Ensure that your fire is positioned away from flammable materials and other sources of ignition at all times.
PAGE 3
Installation FLO, ARROYO Equipment required: Chosen decorative media such as lava rocks or fire/heat suitable pebbles or glass. Confirm quality and suitability of fire accessories to ensure the accessories will not explode, emit carbon monoxide or fumes when exposed to extreme temperature variations. 1. Insert the Adapter Plate into the base (COLLAR FACING UPWARDS). LUMEN Equipment required: Timber/Wood: Pencil, short philips head screw driver, drill and pilot drill bit.
PAGE 4
MESA Equipment required: Short philips head screw driver. 1. Confirm you have received all necessary parts as illustrated. 2. Position the concrete door carefully on a clean/soft surfance and fix the door leg brackets onto the door using 4 x M6 screws. Two on either side as illustrated. 3. Tighten screws when in an upright position to ensure secure. 4. Slide the door into the closed position, The door slides in and out of this position to enable access to the cavity under the model.