Manual

Refer to the section “To Remove The Bolt
Assembly,” page 37. After completing steps
one through seven, you are ready to install
the adapter.
Remove both forearm guide screws from
the front of receiver, near the magazine
tube. (See Figure 4.) Slide the recoil
adapter over the magazine tube so that it
conforms to the contour of the front of the
receiver, and lines up with the screw holes.
Replace screws firmly, but do not
overtighten. Refer to page 39 regarding
reassembly of bolt assembly and trigger
housing. When completed with step seven
on page 42, your B
- 80 is ready to function
with 2 3/4” light target loads. REMEMBER:
When you plan on installing a 3” magnum
barrel to shoot 3” shells, you should
remove the recoil adapter.
As mentioned previously, the recoil adapter
described above needs to be used only on
those B
- 80s manufactured prior to late 1985.
17