Owner's Manual

unloaded. CHECK THE MAGAZINE,
FEED MECHANISM AND CHAMBER
TO BE SURE THEY DO NOT
CONTAIN ANY SHELLS.
2 Unscrew the magazine cap and
remove it.
3 The magazine three-shot adapter
lies underneath the magazine
spring retainer located in the
forward end of the magazine
tube. Pry the magazine spring
retainer out of the magazine
using a flat screwdriver (Figure 7).
Slowly remove the magazine spring retainer as it is under pressure
of the magazine spring. Remove the magazine adapter.
4 Depress the magazine spring back into the magazine tube and replace
the magazine spring retainer. Reinstall the magazine cap. With the
magazine adapter removed, the BPS pump shotgun has the following
capacities:
GAUGE SHELL SIZE WITH 3-SHOT WITHOUT 3-SHOT
ADAPTER ADAPTER
10 2 3/4"
**
2 7/8" 2 5
3"
**
3 1/2" 2 4
12
with 3 1/2" chamber 2 3/4" 2 4
3" 2 3
3 1/2" 2 3
12
without 3 1/2" chamber 2 3/4" 2 4
3" 2 3
20 2 3/4" 2 4
3" 2 3
28 2 3/4" 2 4
.410 bore 2 1/2" 2 4
3" 2 3
* No shell capacities are listed under 10 gauge with 2 3/4" or 3" shells because these
shell lengths are not currently available.
14
FIGURE 7
Pry the magazine spring retainer out of the
magazine.
00401BFA/BPS OM fin 8/7/03 11:17 AM Page 14