Owner's Manual

STANDARD INVECTOR

Pre-1993 BPS models, excluding the 12 gauge 3 1/2" Magnum, are

threaded to accept Standard Invector™ choke tubes. The 28 gauge

and .410 bore BPS are the Standard Invector™.

Invector™ Choke Tubes are made with tempered steel and are fully

compatible with all FACTORY AMMUNITION (loaded in compliance

with SAAMI specifications) including Magnum lead and steel shot

loads and rifled slug loads.

INVECTOR-PLUS™

All current BPS 12 and 20 gauge shotguns, except the Buck Special

and Game Gun, have back-bored barrels and are threaded to accept

Invector-Plus™ choke tubes only. They are not interchangeable with

Standard 12 gauge Invector choke tubes. A special “Plus” choke tube

wrench is provided to remove and tighten these tubes.

DO NOT FIRE THIS SHOTGUN WITHOUT HAVING AN INVECTOR™ CHOKE

TUBE INSTALLED.

Permanent damage may result to the threads.

DO NOT USE BROWNING INVECTOR CHOKE TUBES IN ANY SHOTGUN

BARRELS NOT SUPPLIED BY BROWNING. ALSO, DO NOT USE ANY OTHER

CHOKING DEVICE IN ANY SHOTGUN BARRELS SUPPLIED BY BROWNING.

USE ONLY CHOKE TUBES APPROPRIATELY MARKED EITHER INVECTOR OR

INVECTOR-PLUS™.

CAUTION: WHENEVER HANDLING ANY SHOTGUN FOR THE PURPOSE OF

REMOVING OR INSTALLING A CHOKING DEVICE, MAKE ABSOLUTELY

CERTAIN THE GUN IS FULLY UNLOADED AND THE BOLT OR BREECH IS

OPEN! NEVER ATTEMPT TO REMOVE OR INSTALL A SHOTGUN CHOKING

DEVICE ON A LOADED FIREARM!

TUBE REMOVAL

PLACE THE “SAFETY” IN THE “ON SAFE” POSITION AND OPEN THE

ACTION. UNLOAD YOUR BPS FULLY. INSPECT THE CHAMBER, FEED

MECHANISM AND MAGAZINE TO MAKE SURE THEY DO NOT CONTAIN

ANY SHELLS.

00401BFA/BPS OM fin 8/7/03 11:17 AM Page 18