Owner's Manual

2 Use the Invector™ wrench to loosen the tube, turning it counter-
clockwise. Finger twist the tube the rest of the way out of the barrel.
TUBE INSTALLATION
1 UNLOAD YOUR BPS FULLY. INSPECT THE CHAMBER, FEED MECHANISM
AND MAGAZINE TO MAKE SURE THEY DO NOT CONTAIN ANY SHELLS.
2 Open the action and place the “safety” in the “on safe” position.
3 Before installing a tube, check the internal choke tube threads in the
muzzle, as well as the threads on the Invector™ choke tube to be sure
they are clean. Lightly oil the threads with an oil like Browning Oil.
4 Using your fingers, screw the appropriate tube into the muzzle end of
the barrel, tapered end first, notched end outward. When it becomes
finger-tight, use the Invector choke tube wrench to firmly seat the
tube.
THE INVECTOR™ CHOKE TUBE SHOULD BE PERIODICALLY
CHECKED TO ASSURE THAT IT IS TIGHT AND FIRMLY SEATED. BEFORE
CHECKING, FOLLOW THE SAFETY GUIDELINES ABOVE. ON GAME GUN
MODELS, THE RIFLED CHOKE TUBE TIGHTENS WITH USE. THE RIFLED
CHOKE TUBE SHOULD BE REMOVED AND CLEANED AFTER EVERY 15-20
SHOTS TO AVOID EXCESS TIGHTENING AND TUBE REMOVAL PROBLEMS.
Replacement and additional tubes and wrenches are available from
your local Browning dealer, or by writing to:
Browning Consumer Department
One Browning Place
Morgan, UT 84050-9326
[phone]
Canadian customers please call or write:
Browning Canada Sports Ltd./Ltee
5617 Chemin St-François
St-Laurent, Quebec, Canada H4S 1W6
[phone]
19
00401BFA/BPS OM fin 8/7/03 11:17 AM Page 19