Owner's Manual

SIGHT ADJUSTMENT FOR THE BUCK SPECIAL
AND GAME GUN
The Buck Special and Game Gun are equipped with a precision
rear sight which is screw adjustable for both horizontal and vertical
correction (Figure 11).
WINDAGE ADJUSTMENT
To move the point of impact to the
RIGHT, loosen the screw on the
right side of the sight. Then tighten
the screw on the left side of the
sight. To move the point of impact
to the LEFT, loosen the screw on
the left side of the sight and tighten
the screw on the right side. This
is a process of trial and error. Make
small adjustments, then check the
point of impact.
VERTICAL ADJUSTMENT
Vertical adjustment is controlled by two screws located on top of the
sight. To RAISE the point of impact, loosen the front screw and then
tighten the rear screw. To LOWER the point of impact, loosen the rear
screw and then tighten the front screw. Vertical adjustment is also a
process of trial and error. The “Deer Special” Game Gun is supplied
with a receiver scope mount base. The “Turkey Special” is
drilled and tapped for a scope base.
23
FIGURE 11
Precision rear sight on the Buck Special and
Game Gun.
00401BFA/BPS OM fin 8/7/03 11:17 AM Page 23