Owner's Manual Supplement

ManualsBrandsBrowning ManualsFirearmsCitori/Cynergy Unsingle Rib

ALWAYS KEEP THE MUZZLE POINTED IN A SAFE DIRECTION. BEFORE

STARTING ADJUSTMENT OR DISASSEMBLY PROCEDURES, PLACE THE

“SAFETY” IN THE ON SAFE POSITION, OPEN THE ACTION AND VISUALLY

INSPECT THE CHAMBER(S) TO BE ABSOLUTELY CERTAIN THE FIREARM IS

COMPLETELY UNLOADED. FAILURE TO FOLLOW THIS WARNING COULD

RESULT IN SERIOUS INJURY OR DEATH.

PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS

IN THE OWNER’S MANUAL SUPPLIED WITH YOUR SHOTGUN AND THOSE

FOUND IN THIS SUPPLEMENT BEFORE USING YOUR NEW SHOTGUN.

FAILURE TO FOLLOW THESE INSTRUCTIONS, OR FAILURE TO FOLLOW ANY

SAFETY WARNING, MAY RESULT IN INJURY OR DEATH TO YOURSELF OR

OTHERS, OR MAY CAUSE DAMAGE TO YOUR FIREARM.

If your shotgun owner’s manual is missing, contact the Browning

customer service department immediately at (800) 333-3288 for a

free copy, or download one online at browning.com.

UNSINGLE RIB

ADJUSTMENT

INSTRUCTIONS

OWNER’S MANUAL SUPPLEMENT

Summary of content (4 pages)

PAGE 1
UNSINGLE RIB ADJUSTMENT INSTRUCTIONS OWNER’S MANUAL SUPPLEMENT ALWAYS KEEP THE MUZZLE POINTED IN A SAFE DIRECTION. BEFORE STARTING ADJUSTMENT OR DISASSEMBLY PROCEDURES, PLACE THE “SAFETY” IN THE ON SAFE POSITION, OPEN THE ACTION AND VISUALLY INSPECT THE CHAMBER(S) TO BE ABSOLUTELY CERTAIN THE FIREARM IS COMPLETELY UNLOADED. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH.
PAGE 2
DISCHARGING FIREARMS IN POORLY VENTILATED AREAS, CLEANING FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO LEAD AND OTHER SUBSTANCES KNOWN TO CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND OTHER SERIOUS PHYSICAL INJURY. HAVE ADEQUATE VENTILATION AT ALL TIMES. WASH HANDS THOROUGHLY AFTER EXPOSURE. WEAR EYE PROTECTION WHEN DISASSEMBLING AND CLEANING YOUR SHOTGUN TO PREVENT SPRINGS, SPRING-LOADED PARTS, SOLVENTS OR OTHER AGENTS FROM CONTACTING YOUR EYES, RESULTING IN INJURY.
PAGE 3
FIGURE 1 FIGURE 2 Loosen both screws at the rib pivot point. Turn the thumbscrew to raise or lower the front of the rib. 1 Use a 2mm Allen wrench to loosen both the screws at the rib pivot point, located at the junction of the rib and the barrel assembly just above the front of the forearm (Figure 1). Only loosen the screws enough to allow movement, as completely removing the two screws could cause the loss of small parts contained in the rib pivot point assembly.
PAGE 4
3 The sight picture is adjusted with the rear adjustment screw located on the monoblock just above the chamber area (Figure 3, page 3). It is a spring detent screw, giving audible and tactile clicks as it is adjusted. Using a suitable screwdriver, turn the screw. Clockwise rotation will lower the rear of the rib and counterclockwise will raise the rear of the rib.