Owner's Manual

27
features an approximate range
of ¼" of cast on or cast off
adjustment and
5
/8" of drop at
comb adjustment.
CAST ADJUSTMENT
1 Place the “safety” in the on safe
position. Open the action and
make sure the shotgun is
completely unloaded.
2 Remove the comb by inserting a
7
/64" Allen wrench into the holes
found on the right side of the buttstock. Turn the wrench
counterclockwise to loosen the Allen screws.
3 With the Allen screws loose, lift the comb from the stock.
4 To adjust cast, loosen the two Allen screws located inside of the
posts on the underside of the comb using a
7
/64" Allen wrench
(Figure 16).
5 Adjust the cast by sliding each post equally in the desired direction
(Figure 14, page 26). Hash marks are stamped in the base to aid in
locating the posts on the comb. Each adjustment increment
represents approximately
1
/16".
• Move the posts to the left for more cast off.
• Move the posts to the right for more cast on.
When properly set, the front and rear sight beads should line up
perfectly each time you shoulder your shotgun.
6 With the posts adjusted, carefully secure the Allen screws inside
the two posts. If drop at comb has already been set to your desired
height, return the comb to your shotgun and carefully secure it to
the buttstock by tightening the two Allen screws in the side of the
buttstock. Do not overtighten the screws. If drop has not been set,
proceed to “Drop at Comb Adjustment.”
FIGURE 16
Loosen the Allen screws located inside the
posts to adjust cast.