Owner's Manual

36
are ¼" thick and are available to be used with the recoil pads,
if needed.
2 Place a small amount of petroleum jelly on the tip of a Phillips
screwdriver to avoid damaging the recoil pad when the screwdriver
is inserted.
3 Engage the recoil pad screws with the screwdriver. Turn clockwise
until the screws are tight in the stock. Do not overtighten
the screws.
TRIPLE TRIGGER
™
SYSTEM
BEFORE CHANGING TRIGGERS OR PERFORMING ADJUSTMENT
PROCEDURES, PLACE THE “SAFETY” IN THE ON SAFE POSITION. OPEN
THE ACTION AND MAKE CERTAIN THE CHAMBERS ARE UNLOADED. KEEP
THE MUZZLES POINTED IN A SAFE DIRECTION. FAILURE TO FOLLOW
THESE WARNINGS COULD RESULT IN SERIOUS INJURY OR DEATH.
The Triple Trigger System has three interchangeable trigger shoes with
different surfaces: Wide with checkered surface, wide with canted
smooth surface and narrow with smooth surface. Each trigger shoe is
adjustable to three positions for length of pull. Please heed all safety
warnings, cautions and procedures found in this owner’s manual
when adjusting or installing trigger shoes.
REMOVING THE TRIGGER
Before you begin to remove the trigger, place the “safety” in the
rearward, on safe position to prevent dry firing your shotgun as you
are changing/adjusting trigger shoes.
All Cynergy target models are supplied with three different styles
of trigger shoes. To remove the trigger shoe, loosen the center screw
with the provided 2mm (
5
/64") Allen wrench (Figure 26, page 37).
Loosen the screw so the trigger shoe slides easily on the trigger plate.