Instructions / Assembly

SC2039002-BN-00 - ENG Page 6 of 24 20121206-V1
DANGER
 The safety relief valve on the LP tank could activate the releasing of gas and cause
an intense fire with risk of death or serious injury. Therefore, follow instructions below
exactly.
A. Do not store a spare LP-gas cylinder under or near this appliance.
B. Never fill the cylinder beyond 80 percent full.
C. If the instructions in (A) and (B) are not followed exactly, a fire causing death or
serious injury may occur.
 If you see, smell, or hear escaping gas, immediately get away from the LP tank /
appliance and call your FIRE DEPARTMENT.
 All spare LP tanks must have safety caps installed on the LP tank outlet.
LP Tank Removal, Transport and Storage
 Turn OFF control knobs at regulator and LP tank valve. Turn coupling nut
counterclockwise by hand only – DO NOT USE TOOLS TO DISCONNECT. Place dust
cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of
dust cap on the cylinder valve outlet that is provided with the cylinder valve. Other
types of caps or plugs may result in leakage of propane.
 A disconnected LP tank in storage or being transported must
have a safety cap installed as shown. Do not store an LP tank
in enclosed spaces such as a carport, garage, porch, covered
patio or other building. Never leave an LP tank inside a vehicle
which may become overheated by the sun.
 Storage of an appliance indoors is permissible only if the
cylinder is disconnected and removed from the appliance.
 Cylinder must be stored outdoors out of the reach of children
and must not be stored in a building, garage or any other
enclosed area.
 Turn off gas at supply cylinder when not in use.
LP Tank
The LP tank used with your appliance must meet the following requirements:
 Purchase LP tanks only with these required measurements: 12”(30.5cm)(diameter) x
18”(45.7cm)(tall) with 20lb.(9kg) capacity maximum.
 The LP-gas supply cylinder to be used must be constructed and marked in accordance
with the specifications for LP-gas cylinders of the US Department of Transportation
(DOT) or the National Standard of Canada, CAN/CSA-B339, Cylinders, Spheres and
Tubes for the Transportation of Dangerous Goods.
LP tank valve must have:
 Type 1 outlet compatible with regulator or appliance.
 Safety relief valve.
 UL listed Overfill Protection Device (OPD). This OPD safety
feature is identified by a unique triangular hand wheel. Use
only tanks equipped with this type of valve.
LP tank must be arranged for vapor withdrawal and include collar to
protect LP tank valve.
LP(Liquefied Petroleum Gas)
 LP gas is non-toxic, odorless and colorless when produced. For your safety, LP gas
has an odor (similar to rotten eggs) so that it can be smelled.
 LP gas is highly flammable and may ignite unexpectedly when mixed with air.