BR-RC1190-Mod User Guide Dec 12, 2022 Rev A5
BR-RC1190-Mod User Guide Contents Functional Description .................................................................................................................................................................................... 3 Overview .................................................................................................................................................................................................... 3 Applications ..................................................
BR-RC1190-Mod User Guide Functional Description Overview The BR-RC1190-Mod is a multi-channel RF transceiver module designed for GFSK operation in the 902-928MHz frequency band. It uses the Embedded RC232 protocol and features a two-wire UART interface. The module is shielded and is certified as a modular transmitter in the following countries: US (FCC), Canada (IC/ISED RSS).
BR-RC1190-Mod User Guide All configuration settings and RAM values are retained in sleep mode. Interfaces Power Supplies Power is supplied through the VCC pin by applying 5V +-10%. Module Reset The module can be reset by driving the RESET pin low. RF Antenna Interface The BR-RC1190-Mod has been certified to be used with an external antenna (Linx p/n: ANT-916-CW-HD). The antenna connects to the module through an RF connector.
BR-RC1190-Mod User Guide RESET, CONFIG Reset, config control pins -0.5 6.5 V Max Unit Recommended Operating Conditions Parameter Min Typ VCC 4.5 5.0 5.5 V VIH (RXD, TXD, RESET, CONFIG) VCC x 0.65 - VCC V VIL (RXD, TXD, RESET, CONFIG) 0 - VCC x 0.35 V Mechanical Specifications (top view) 35.05 2.54 x22 11.60 36.83 38.10 1.60 0.00 24.10 5.30 0.00 1.27 5.80 5.28 Qualifications and Approvals Country Approvals The BR-RC1190-Mod is certified for use in the following countries.
BR-RC1190-Mod User Guide 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the Federal Communication Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
BR-RC1190-Mod User Guide Cet équipement est conforme avec ISED RSS-102 des limites d'exposition aux rayonnements définies pour un environnement non contrôlé. Cet émetteur ne doit pas être colocalisé ou fonctionner en association avec une autre antenne ou émetteur. End-Product User Manual Instructions NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE.
BR-RC1190-Mod User Guide Approved Antenna ANT-916-CW-HD Manufacturer Linx Center Frequency 916MHz Wavelength ¼-wave VSWR ≤2.0 typical at center Peak Gain -0.3dBi Impedance 50ohms Size Ø12.3mm x 65mm Type Omni-directional Connector RP-SMA 92 Advance Rd. Toronto, ON. M8Z 2T7 Canada Tel: 416 231 5535 www.broy.
