User's Guide

BR-RC1190-Mod User Guide
92 Advance Rd. Toronto, ON. M8Z 2T7 Canada
Tel: [phone] www.broy.com
Cet équipement est conforme avec ISED RSS-102 des limites d'exposition aux rayonnements définies pour un environnement non
contrôlé. Cet émetteur ne doit pas être colocalisé ou fonctionner en association avec une autre antenne ou émetteur.
End-Product User Manual Instructions
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: The BR-RC1190-Mod has been tested and approved with Linx antenna p/n: ANT-916-CW-HD. The end-product must be used with
the same antenna.
NOTE: The end-product must not use a transmission duty cycle greater than 30%.
The BR-RC1190-Mod can be placed into several test modes to facilitate EMC testing of the end-product. For more information on the
available test modes and procedures to place the device in test modes, please refer to the following documents:
- Radiocrafts TM/RC232 Configuration and Communication Tool (CCT) User Manual.
- Radiocrafts RC232 User Manual
- RC11xx-RC232 Datasheet (RC1190-RC232)
The following test modes are available:
- Test Mode 0 – List Configuration Memory
- Test Mode 1 – TX Carrier
- Test Mode 2 – TX modulated signal, PN9 sequence
- Test Mode 3 – RX mode, TX off
- Test Mode 4 – IDLE, Radio off
End-Product Labeling Requirements
The manufacturer of the end-product must have the following labeling in their manual:
Contains FCC ID: 2A8AC-BRRC1190MOD
Contains IC: 28892-BRRC1190MOD
End-Product Compliance
The modular transmitter is only FCC authorized for the specific rule parts listed on the grant. The end-product manufacturer is
responsible for compliance to any other FCC rules that apply to the end-product not covered by the modular transmitter grant of
certification.
This radio transmitter [enter the device’s ISED certification number] has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types listed in the Approved Antennas section, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly
prohibited for use with this device