User's Manual

Product Specification and User Manual RFID GEN3 System
CONFIDENTIAL
Page 22 of 34
4 RFID GEN3 Electrical Specification
4.1 Connector
The electrical connection between the RFID Post shall use the sealed connector Delphi
GT 150 series. Refer to product drawing for more details.
Figure 8: CAN Variant Connector Figure 9: MOWP Variant Connector
The following table outlines the RFID Post’s pinout.
Pin CAN Variant – Pin Name MOWP Variant – Pin Name Type
A GND GND Power
B CONTACT CONTACT Signal
C CAN Lo 1-WIRE/MOWP Communication
D VBATT VBATT Power
E CAN H - Communication
Table 4: RFID GEN3 Post Pinout