User's Manual

Product Specification and User Manual RFID GEN3 System
CONFIDENTIAL
Page 26 of 34
7 Localization and Installation on Vehicle
The RFID GEN3 System shall be installed as the previous DESS System generation. The
RFID Post should be secured to the vehicle’s body using the Post retaining ring
278 002 963. The Post’s sphere and thread must protrude out of the vehicle’s body and
be accessible by the operator, while the Post’s main body shall be inside the vehicle’s
body.
Figure 10: Example of Vehicle Installation
7.1 Metallic Materials.
The RFID Post shall be located away from any metallic material of the body works; 5 cm
of clearance in any direction shall be observed. In cases this cannot be respected, the
intended mounting position shall be validated by a performance measurement using the
diagnostic tool described in section 8.