User's Manual

Product Specification and User Manual RFID GEN3 System
CONFIDENTIAL
Page 31 of 34
8.2.1 Radiated Noise Validation
The main purpose of this validation is to determine whether the RFID GEN3 System is in
the presence of a radiated noise source that could potentially affect the transmission of
the RF transmission between the RFID Key and Post. The vehicle under test shall be
started in regular operation. The RF Diagnostic tool should be connected as shown in the
Figure 13.
Figure 13: Configuration for Radiated Noise Validation.
Once the system is powered-up and the vehicle is started, the diagnostic tool can be used
to monitor whether noise sources could be affecting the performance of the RFID GEN3
System. The document 000004 FO-QA-029-KA SKIDOO TUNDRA 600 ETEC Radiation
Problems, can be used as guidance for measurement or noise source identification.