Specifications

35
OUTBOARD INSTALLATION
TRANSOM MEASURING AND DRILLING
2
Before drilling any mounting holes:
• Make sure the hole locations provide enough
clearance for mounting bolts and washers.
• Check the inside area of the transom for
obstructions.
• Check transom height(s) at centerlines.
Drill four ½ in. (13 mm) mounting holes in the
appropriate locations.
IMPORTANT: Be sure to drill the required holes
perpendicular to transom surface.
40–65 HP, MANUAL TILT MODELS
25–30 HP, MANUAL TILT MODELS
15 HP, POWER TILT MODELS
Center the outboard on the transom (or mounting
bracket) and tighten clamp screws by hand.
Use each stern bracket’s mounting holes as a
guide to drill holes through the transom.
• 40–65 HP models require four 5/16 in. (8 mm)
holes
• 25–30 HP models require two 5/16 in. (8 mm)
holes
• 15 HP models require four 5/16 in. (8 mm)
holes.
40 – 65 HP Models 002215
25 – 30 HP Models 007998
15 HP Models 007999
1
1
1
1
1
1