Specifications

57
OUTBOARD RIGGING
EVINRUDE E-TEC 90° V MODELS 200–300 HP
3
current, resulting in erratic operation of the
remote control system.
For more information, refer to the Evinrude ICON
Remote Control System Installation Guide,
P/N 764952.
Water Pressure Gauge
To display engine water pressure, install a water
pressure hose fitting in the cylinder block as
shown.
Use Pipe Sealant with Teflon on the threads of the
hose fitting. Refer to installation instructions sup-
plied with gauge.
Route the water pressure hose around the star-
board side of the powerhead along the same path
as the battery cables.
For an I-Command water pressure display, sev-
eral water pressure sensor kits are available.
Refer to the Evinrude/Johnson Genuine Parts
and Accessories catalog.
To send water pressure data to the EMM, along
with an I-Command display, install Water Pressure
Transducer Kit, P/N 5008300.
Connect the transducer lead to the engine wiring
harness connector.
1. Water pressure hose fitting 005035
1
1. Water pressure transducer 008131
1. Water pressure transducer lead
2. Engine harness connector
004120
1
1
2