Specifications

61
OUTBOARD RIGGING
EVINRUDE E-TEC 60° V MODELS 115–200 HP
3
Connect outboard main wire harness to boat wire
harness. Secure connectors in brackets.
Route oil tank sending unit harness around the
front to the port side. Secure all cables with tie
straps.
Secure all cables with tie-straps.
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
do not interfere with moving throttle or shift
linkages.
Replace flywheel/harness connector cover.
I-Command Network Connections
If the outboard will be used with I-Command, or
other NMEA 2000 compliant CANbus instruments,
use the following connections to supply informa-
tion to the network:
If using an Evinrude ICON control system, the I-
Command Engine Interface Cable, Power Supply
Kit, and Ignition and Trim Harness are not
required. Connect the I-Command network
directly to the ICON gateway module. Refer to
Evinrude ICON / I-Command Harness Connec-
tions on p. 14.
If using a mechanical control system, connect the
I-Command Engine Interface Cable to the EMM
CANbus connector.
1. Harness connections 004951
1. Low oil sender connection
2. Tie straps
004952
1. Anchor points 005270
1
1
2
1
1. EMM CANbus connector 005267
NOTICE
1