Specifications

73
OUTBOARD RIGGING
EVINRUDE E-TEC MODELS 15–30 HP
3
SystemCheck Harness
Connections
Before installing electrical connectors, check that
the seal is in place. Clean off any dirt from con-
nectors. Apply a light coat of Electrical Grease to
the seal only. DO NOT fill connectors with Electri-
cal Grease.
Route electrical harness along the edge of the
lower engine cover.
Secure connectors to lower motor cover with two
tie straps as shown.
Route trim and tilt connector under air silencer.
Use tie strap to secure connector as shown.
Install battery cables and secure with tie strap.
Route battery cable through grommet of port
lower motor cover.
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
do not interfere with moving throttle or shift
linkages.
1. Seal 42079A
1. Key switch connector
2. Tachometer connector
007263
1. Wire routing
2. Secure with two tie straps
007125
1
2
1
1
2
1. Trim and tilt connector 007264
1. Tie strap 007240
1. Battery cable grommet 008009
1
2
1
1
NOTICE