Installation Sheet

www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without
notice, specications or materials that in our opinion will not alter the function of the product.
Ledra Brands Inc.
15774 Gateway Circle
Tustin, CA 92780
p:714.259.9959
f:714.259.9969
WARNING - PLEASE READ ALL
INSTRUCTIONS PRIOR TO INSTALLATION
INSTRUCTIONS FOR USE
REMOVAL
READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS BEFORE
INSTALLING OR MAINTAINING THIS PRODUCT.
TURN OFF POWER PRIOR TO ANY WORK ON THE SYSTEM OR
PRODUCT
DO NOT INSTALL DAMAGED PRODUCT.
Installing, wiring and maintenance must be done by qualied persons or a
certied electrician in accordance with all local and National Electrical Code.
Warranty is voided in case of unauthorized modications and/ or improper use.
Save these instructions. Use as reference when service or maintenance is
performed.
CAUTION – Do not install any xture assembly closer than 6 inches from any
combustible material.
Do not install any part of a ZONYX track system less than 7 feet above the
oor.
Do not attempt to energize anything other than ZONYX track luminaires on
track.
Suitable for dry locations only
De-engergize circuit before installation.
To attach xture to Zonyx track, slide it from top and press into track.
Close part (A) and install cap (B).
Energize circuit and test for proper operation.
De-energize circuit before removal.
Hold Zonyx track adapter and unscrew cap (B).
Open part (A) and remove adapter from track.
Reposition or replace as required.
Energize circuit and test for proper operation.
1
2
3
1
2
3
4
5
ZONYX Fixture Mounting
Installation Instructions
v.6.6.16
ADAPTER
The Zonyx adapter clamps directly onto the track. Make sure
the lamp is secure in the socket and the fixture is attached to
the adapter. Do not connect track with parts other than those
stated for Zonyx system. All connections after installing or
adjusting the fixture must be clean and tight to avoid arcing and
overheating; failure to do so may result in subsequent lamp,
fixture, or system failure.
IMPORTANT WARNING! - When turning the retaining collar
(B), adjusting the direction of the fixture, or moving the fixture
in any way DO NOT loosen the adapter receptacle (A). Tighten
the receptacle (A) by turning in a clockwise direction. All
connections after installing or adjusting the fixture must be
clean and tight to avoid arcing and overheating; failure to do so
may result in subsequent lamp, fixture, or system failure!
B
A