View Wind Protector Brulo – Markerkant 10-13F – 1316AA – Almere – +31(0)36 30 20 699
The Carton include following parts:Stand fix (X 1piece) The cassette part (X1piece)Brackets (2xpcs) 6x75 expansion bolt (4xpcs) 8x pcs5x40 cross 8x pcs5 washer 8x45 expansion tube (8pcs) Brulo – Markerkant 10-13F – 1316AA – Almere – +31(0)36 30 20 699
Instruction manual (1pcs) Please prepare the following tools before installation, these tools are not provided 1Tape measure 2Hexagonal spanner CR-V5mm 3Cross crewdriver 4Electric hammer Installation Steps Warning: When mounting the awning, keep the main part and stand column on the horizon or the fabric will deformation and difficult to open and close.
Drill 8 cm deep holes in the wall as the following picture shows Insert the 8x45mm plastic expansion tube in each of the holes.
Insert the cassette part into the bracket, tighten the flat fillister head screw m6x16mm with Hexagonal spanner CR-V5mm Drill four 10mm diameter holes on the floor in the size as the following picture shows.
Insert 6x75mm expansion bolts into 10mm holes through the stand fix, then tighten screws with wrench. Correct use Keeping the front bar upright, hold the handle and push it above the stand column.Hold the handle and press the handle spindle that the pint come into the handle, and then put the handle into the stand column.
When you want to close the it hold the handle and pull up the handle slowly. When rolling back the fabric keep it horizontal and push the handle back to the cover slowly.
Guarantee Brulo products provide two year manufacturer warranty. This warranty will be valid from the date of purchase as shown on your invoice. In case of any problems with the product, please contact the company that sold you the item or contact our Brulo Guarantee Contact center. The warranty only applies upon provision of a dated invoice and will be strictly limited to the defect part. Brulo is not liable for any direct or indirect consequences of improper use of the awning.
