SRE-2010 ELECTRA-RIDE™ ELITE STAIRWAY ELEVATOR Operator’s Manual Technical Service email: service@bruno.com www.bruno.com 1780 EXECUTIVE DR., P.O. BOX 84, OCONOMOWOC, WI 53066 USA TELEPHONE:(262) 567-4990 FAX: (262) 953-5501 1-800-882-8183 REV.
PRODUCT REGISTRATION FORM Product Registration Form Please print in CAPITAL letters. Online registration available at http://www.bruno.com/warranty.html Please be assured that Bruno does not share or sell the information you provide. * = required field E *First Name ______________________________________________________ M.I._____ *Last Name _______________________________________________________________ *Street Address ________________________________________________ Apt. No.
Table of Contents Regulatory Information and Specifications . . . . . . . . . . . . . 4 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-6 Parts of the SRE-2010 . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Circuit Breaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Seating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CSA CERTIFICATION The "C" and "US" indicators adjacent to the CSA Mark signify that the product has been evaluated to the applicable CSA and ANSI/UL Standards, for use in Canada and the U.S., respectively. This "US" indicator includes products eligible to bear the "NRTL" indicator. NRTL, i.e. National Recognized Testing Laboratory, is a designation granted by the U.S. Occupational Safety and Health Administration (OSHA) to laboratories which have been recognized to perform certification to U.S. Standards.
FOR YOUR SAFETY • Read and understand the operating instructions, and all safety precautions prior to using the SRE-2010. • Be sure stairs are clear of objects before operating the stairway elevator. • Always be aware of the surface onto which you are stepping as you get on and off the stairway elevator. • Avoid carrying items with you on the stairway elevator which could hinder movement of the elevator up and down the stairs. • Do not wear LOOSE clothing that could interfere with elevator movement.
FOR YOUR SAFETY Each stairway elevator is designed to descend the stairway at a slightly slower speed than is the case when travelling UP. The footrest is equipped with obstruction sensors which stop the carriage if an obstacle is encountered on the stairs. If this should occur, press the opposite side of the UP/DOWN rocker control switch (on the armrest) to run the carriage in the opposite direction. Clear the obstacle from the stairway or rail then resume travel in the desired direction.
SRE-2010 ELECTRA-RIDE™ ELITE armrest UP / DOWN rocker switch swivel release folding seat in riding position folding footrest with obstruction sensors ©2008,2007 Bruno Independent Living Aids, Inc.
CIRCUIT BREAKER The SRE-2010 includes an ON/OFF switch with a built-in circuit breaker located on the back side of the carriage. The circuit breaker protects the battery, controller and motor circuits in the stairway elevator carriage. It is unlikely that this circuit breaker will trip during normal use. However, if the elevator becomes inoperative, check the circuit breaker as a first troubleshooting step. Reset it, if necessary.
SEATING The seat assembly on the SRE-2010 is designed to swivel 90 degrees (with standard armrests) to the left and to the right, and to lock in one of the following positions: 0, 60, and 90 degrees at the top, and 45 degrees at the bottom. UP/DOWN rocker switch Pull up on either the right- or left-side swivel latch located under the seat to swivel the seat to a convenient position for transferring into or out of the seat.
OPERATION 1. Position yourself in the seat. The SRE-2010 includes a “soft-start” feature which prevents the unit from moving abruptly the instant the UP/DOWN switch is pressed. 2. Fasten the positioning belt. Press and hold the switch for a moment to begin the gentle acceleration of the stairway elevator to operating speed. 5. R elease the seat swivel lever to secure the seat in that position.
OPERATION 8. Once you have reached the top or bottom landing, release the rocker switch. Two (2) remote call / send transmitters enable you to move the carriage to or from either end of the stair rail. 9. Raise and hold the seat swivel lever as you rotate to the position for transferring from the seat. 10. Release the seat swivel lever and allow the seat to lock in this position. 11. Unbuckle the positioning belt and carefully exit the seat. ©2008,2007 Bruno Independent Living Aids, Inc.
OPERATION Optional Mid-Park Position The mid-park is available as an option. This feature will let you park and charge the unit at a position between the two ends of the rail. This allows for more room at the top and bottom of the stairs. 1. P ush either the seat rocker switch or the remote call/send to move the stairway elevator up or down the rail. NOTE: T he seat will always stop and beep once when it reaches the mid-park position. 2.
DIAGNOSTIC CODES (UNDER SEAT) C1 Charging C2 Off Charge C3 Off Charge and Not Parked C4 Parked and Charger Not Detected C5 Battery Voltage Critical C6 Battery Voltage Low L1 Seat Safety Switch Open L2 Up Limit Switch Open L3 Down Limit Switch Open L5 Seat Fold Switch Open L6 Mid-Rail Park Active L8 Soft Stop Switch ©2008,2007 Bruno Independent Living Aids, Inc.
CHARGING Keep the batteries charged t o ensure optimal operation of your SRE-2010. The batteries are charging whenever the carriage is parked tightly against the brackets at either end of the rail. Whenever the carriage does not contact the upper or lower charge bracket, the batteries will slowly discharge. Failure to keep the batteries charged, or allowing them to fully discharge, will significantly shorten the life of the batteries.
BATTERY CHARGER LED’S charging power on RED YELLOW ready GREEN STATUS ON OFF OFF charger not connected to battery (AC power ON, no battery connected) ON (5 sec.) ON (5 sec.) ON (5 sec.
BATTERY CHARGER FUSE REPLACEMENT fuse If the charger is subject to a power line surge, the AC input fuse may blow. Refer to the illustration to the left for fuse location. To replace fuse: 1. T urn OFF the battery charger power switch. 2. R emove power cord from wall outlet. charger power switch 3. T wist the fuseholder cap and pull out to remove the fuse. 4. R eplace with the same size and type fuse: (Bussmann GMD-2A or equivalent) 2A, Slo-Blow, 5 x 20mm.
MAINTENANCE Your SRE-2010 is designed to provide many years of reliable service with minimal maintenance. For best service life: • Keep the rail channel clean and free of debris. •A lways park the carriage at one end of the rail so that the batteries charge when the elevator is not in use. •K eep the battery charger plugged into a live outlet at all times. •A t least once a year, have the elevator examined, cleaned and lubricated by a qualified, authorized Bruno service technician.
TROUBLESHOOTING Your SRE-2010 is not operating correctly. What should you do? Before calling your Bruno dealer, refer to the solutions listed below. This could save you an unnecessary service call! • Seat swivel. Is the seat locked in the riding position? • Footrest. Is there an obstruction on the stairway that the footrest is contacting? • Carriage safety panels. I s there an obstruction on the stairway that the carriage safety panels are contacting? • Main circuit breaker (or fuse) panel of residence.
TROUBLESHOOTING (CONTINUED) • Battery charger (continued). C onfirm that the charger is plugged into a live outlet and wait for the batteries to charge. Is the charger plugged into a functional outlet? Do not use outlets which are controlled by a wall switch. Is the power light on? • Visual check.
VACATION AND LONG-TERM STORAGE If the SRE-2010 will remain unused for an extended period of time, turn off the circuit breaker, then unplug the battery charger from the wall outlet. NOTE: T he batteries may require recharging before normal use if the stairway elevator remained unused for an extended period of time. To recharge, simply turn on the circuit breaker, reconnect the charger to the wall outlet and wait until the charger LED’s indicate that the batteries are fully recharged.
FIVE YEAR MAJOR COMPONENTS WARRANTY TWO YEAR LIMITED WARRANTY for Bruno Stairlifts Bruno Independent Living Aids, Inc. (“Bruno”), warrants to the original purchaser of a Bruno Stairlift that the Bruno Stairlift is free from defects in material and workmanship for a period of two years from date of purchase. In addition, Bruno warrants that the motor, gear box and rail (the “Major Components”) will be free from defects in materials and workmanship for a period of five years from the date of purchase.
To obtain warranty service, you must follow these procedures: 1. Obtain return authorization by calling your local Bruno dealer; 2. Return the Bruno Stairlift, freight prepaid, to the address provided by your Bruno dealer or Bruno with proof of purchase indicating the date purchased. Bruno will pay for shipping back to the purchaser within the continental United States and Canada if a defect in material or workmanship is discovered.
First in Performance. Built to Last! Straight & Custom Curved-Rail Stairlifts Vertical Platform Lift Over 25 Different Vehicle Lift Solutions Turning Automotive Seating Bruno Independent Living Aids, Inc® 1780 Executive Drive, P.O. Box 84, Oconomowoc, WI 53066 262-567-4990 • FAX: 262-953-5501 • www.bruno.com ©2006 Bruno Independent Living Aids, Inc.® All illustrations and specifications in this brochure are based on the latest product information available at the time of publication.
