Installation manual

17
SRE-2000C 11-14-2007
©2007,2001 BRUNO INDEPENDENT LIVING AIDS, INC.®
1-1/4”
IMPORTANT NOTES
The rail must rest approximately
1-1/4 inches (32 mm) above the
step nose of EVERY step, and
extend from the oor at the
bottom of the stairs to a point
beyond the nose of the top step
(see Application Guide Step 4).
It may be necessary to pound
a scratch awl in one of the rear
clamp mounting holes to prevent
the rail from sliding.
Rail-to-step nose distance must
INCREASE TO 1.5” (38 mm)
if
extended footrest assembly
is used.
step nose to bottom of rail = 1-1/4” (32 mm)
Clearance!
Stair proles do vary, so it is
critical to ensure proper clearance
between the step nose and the
bottom of the rail.
Failure to install the rail at the
specied 1-1/4” (32 mm) distance
from the step nose will cause the
footrest to contact to steps, thus
provoking intermittent operation
of the stairway elevator. If neces-
sary, gently slide rail and clamps
toward or away from the stair
riser to adjust the clearance to the
1-1/4 in. recommanded distance.
INSTALLATION