Installation guide

Chapter 7: Plug In and Setup 49
Dual Wireless Keypads
If you have dual keypads that will be used to wirelessly control one lane per keypad, then you must first set the
following channel numbers:
Odd Lane: Set the Channel Number on both the Rotary DIP switches to 10
(One on the 10’s switch and Zero on the 1’s switch)
Even Lane: Set the Channel Number on both the Rotary DIP switches to 20
(Two on the 10’s switch and Zero on the 1’s switch)
Once this is done, each keypad will send out a signal to the Duo CPU module, stating that the keystroke was
for the odd or the even lane.
Note: If you change the channel number on the Keypad PCB, then you must re-boot it by
unplugging the cable from the LLAN IN port and then plug it back in.