Installation guide

Chapter 8: Using the Setup Wizard 57
The full text of this warning is as follows:
Light Ball Triggering in NOT required by this Scoring System.
Enabling this feature will result in the Pinsetter/Pinspotter
being cycled a time delay period after the Ball Detection beam
at the Score Camera has been cut.
The manufacturer of this equipment does NOT require Light
Ball triggering in order to determine and report the score.
If Light Ball Triggering is enabled it is the sole responsibility of
the proprietor of this center to initiate and maintain all
necessary safety systems to protect the safety of all persons
within this center. Such safety systems include, but are not
limited too,
1. Appropriate Warning Signs.
2. Written and enforced procedures in regards the safe
operation of the Pinsetters/Pinspotters.
3. Training of all staff in safe operating procedures.
4. Device(s) capable of monitoring unauthorised personnel
approaching the pinsetters/pinspotters.
The manufacturer does not accept any liability whatsoever for
the operation of Light Ball Triggering and merely provides this
feature upon the discretion of the proprietor of this center.
He/she must make themselves aware of all possible
consequences of this method of triggering the
pinsetter/pinspotter, BEFORE enabling this feature.
This feature is to be enabled by an authorized representative
of the proprietor of this center only.
The proprietor of this center is advised to seek advice from
his/her attorney prior to enabling this feature.
By choosing to accept these conditions the proprietor of this
center is agreeing to them.
As with any light ball triggering system, moving machinery will be automatically activated whenever the ball detector
beam is cut. It HIGHLY RECOMMENDED that you DO NOT use Light Ball Triggering UNLESS you have properly
thought out, acted and accepted all its implications.
Note: If Light Ball Triggering is enabled, a cycle signal will NOT be sent to the
Pinsetter in the following situations:
1. If the Ball Detector beam is cut twice.
2. If the Ball Detector beam is cut for a long time. (Approx 2 seconds)