Installation guide

Chapter 9: Setup the Optional Computers and Printers 71
4. Then, select the desired printer from the list on detected network printers.
5. Windows should then automatically install the printer driver.
6. Set the printer as the default, only if this printer will be used to print system reports.
7. Perform a Test Print from Windows for each printer on every computer.
8. Repeat this until all computers have all shared printers installed.
6. Install the Software
Only once all the above steps have been performed and tested as working, you are then able to continue on
to install the Center Command software.
This last step is discussed in the next chapter.