Installation guide

Introduction 2
Power Requirements
There are at least two power circuits that need to be present for the system to function (Shown in Pink, below):
1. Display Units. There must be a power available to the display units in the ceiling. There must
be a GPO (General Purpose Outlet) for each monitor and also one for the Duo
unit. There is a maximum of 8 lanes per circuit or lower, depending on your local
power regulations.
2. Computer Equipment. There must also be a separate circuit available for the front end Computer
Equipment. It is recommended that this circuit not only is separate from the Duo
Units and Monitors, but it should also be on a separate circuit from the remainder
of the center’s power.
Note: A licensed electrician MUST do Any high voltage electrical work. It may be
necessary to contact a licensed electrician to pre-install these power circuits
BEFORE starting installation.