Operation Manual

Table Of Contents

SMARTCRAFT CONNECT GATEWAY OPERATION MANUAL

SmartCraft Connect Module—Single through Quad Engine

NOTE: The Connect module does not provide power for any device on the NMEA 2000 network. The NMEA 2000 network

will require its own power source. The NMEA power input must have appropriate circuit protection for the devices on the

NMEA 2000 network.

NOTE: The termination band on the 10‑pin connector cable only applies to under cowl mounted modules.

a - CAN P connection light

b - NMEA connection light

c - CAN H connection light

d - WIFI connection light

e - Bluetooth® connection light

f - NMEA 2000® connector

g - 10‑pin connector

Module Harness Connections

Under Helm

1. Connect the SmartCraft Connect module in one of the two following ways:

a. Connect the CAN 10‑pin harness connector to the SmartCraft junction box. Refer to the following diagram.

b. Connect the CAN 10‑pin harness connector to the helm harness SmartCraft 10‑pin connection using a male‑male

adapter harness.

TERMINATED

ENGINE MOUNT ONLY

71912