Use and Care Manual

Rev: 5 06/2016 Brush Master™ Chipper/Shredder with 2-Way Feed
3
T
Component Identification
Recoil Starter
The starter handle is located on
the engine. Pull the starter handle
to start engine.
Leaf Funnel
Use the Leaf funnel to feed
leaves and branches no larger
than 1/4” only.
Limb Chute
Use the Limb chute to feed
longer and/or thicker pieces of
yard waste into the impeller for
chipping. Depending on the
model #, the chipper/shredder
can cut up to a 2.25” or 3” or
5”×3.5“diameter piece of wood.
Discharge Chute
Chipped materials are
discharged through this opening.
Fuel Tank
Use regular unleaded fuel. Always
leave about 1” of air gap at the top
of the tank for fuel expansion to
prevent seepage or spills.
Hardware Bag (Not shown)
This bag contains the owner's manual,
assembly hardware, tools, safety glasses
and oil fill funnel
On/Off Switch
Set this to On before using recoil
starter. Set switch to Off to turn off
engine.
Choke Lever
Move the choke lever to the
CHOKE position to prepare a
cold engine for starting.
Fuel Valve
Use the fuel valve to turn fuel on
and off to engine.
If you are missing any parts, please complete the form on the next page and fax it to us at: 919-550-3277.
Serial #:
Stamped on engine block
between funnel and engine