Use and Care Manual

Rev: 4.5/15/12 Brush Master™ Chipper/Shredder with 2-Way Feed

Assembly

IMPORTANT: This unit is shipped without gasoline or oil in the

engine. Be certain to fill the engine with gasoline and oil as

instructed before operating your machine.

Required tools: Two 13mm wrenches

NOTE: Both wrenches are supplied in the hardware bag.

Approximate assembly time: 15 minutes

1. Remove the chipper from its carton

Remove plastic banding and cut the tape on the top of the

box.

3. Verify all chipper components are present (Figure 1)

Item 1: Engine/chipper body/wheels subassembly

Item 2: Lower leaf funnel section

Item 3: Upper leaf funnel section with entry shield

Item 4: Handle section and leaf funnel base

Item 5: Discharge chute with deflector

NOTE: Fill out and submit missing parts request form on

page 4 should any parts be missing.

4. Verify all parts are in the hardware bag (Figure 2)

 Goggles (eye protection)

 Wrenches for assembly and blade maintenance

 Allen wrench for blade maintenance

 Oil funnel with flexible neck

 Spark plug wrench

 Owner’s Manual

 Hardware: eleven 20mm long bolts, two 30mm long

bolts, two 45mm long bolts, 26 flat washers, 4 locking

washers and 11 nylon locking nuts

Figure 2

2. Remove the shipping frame (item 6) from item 1

The steel shipping frame (item 6) is banded to the base of

the chipper at the engine mounting location. Cut these

bands with scissors or a knife to remove the chipper from

the shipping frame. The shipping frame can be discarded.

Bolt Identification:

Place top of bolt head here

Actual Size

20mm

45mm 30mm

Figure 1