Use and Care Manual

IMPORTANT SAFETY INFORMATION
Read and understand all safety precautions and
instructions before use.
The Brush Grubber is designed for outdoor use.
Check Brush grubber before each and every use for
signs of wear.
The Brush Grubber is designed to remove brush up
to 3” diameter.
The Brush Grubber is not to be used on people or
pets.
INSTRUCTIONS
1. Place Brush Grubber on each side of trunk of brush near the base/ground with spring on Brush Grubber placed towards
the ground as shown in gure 1. It is recommended to cut brush o approximately 2-4 feet above the
ground prior to removal of stump.
2. Securely Attach a chain to the clevis of Brush Grubber and the opposite end of chain towing/pulling vehicle.
Take caution that the chain is long enough so the brush will not hit/strike the operator of the towing/pulling vehicle.
Do Not jerk the Brush Grubber while there is slack in the chain.
3. To remove Brush Grubber from the trunk of brush push back on the clevis (towards the trunk). Take caution of all pinch
points on the Brush Grubber.
* Take caution of all pinch points on the Brush Grubber.
* Take caution of grip pads when opening the jaws of the Brush Grubber. Keep ngers and hands free and clear.
PH: 952-945-9058
www.brushgrubber.com
Email: [e-mail]
Brushgrubber.com
PO BOX 5064
HOPKINS, MN 55343
WARNING
BAC Industries, Inc. and Brush Grubber will not be held liable for any damages, losses or injury due to the misapplication or misuse of
this product or any other reason. Always wear approved safety glasses, protective clothing, and proper hand and foot protection at all
times. Keep all people, pets, or animals clear from brush removal work area.
Figure 1
FOR ANY QUESTIONS PLEASE CONTACT OUR OFFICE OR VISIT WWW.BRUSHGRUBBER.COM