Use And Care Manual

- 10 -

STEP7: Attach the Hydraulic Hose

1. Attach the hydraulic hose(#39) to the oil outlet connector of gear pump, put in O ring

Ø11.2x2.4 (#32)

2. Attach hydraulic hose (#42) to connector of the outer oil filter, put in O ringØ17x2.5 (#33).

Note: Tighten hydraulic hose connector between torque of 80-90N

STEP 8: Add Engine Oil

1. Make sure the log splitter is on a level surface.

2. Remove oil fill cap/dipstick to add oil.

3. Refer to the separate owner’s engine manual for the amount needed of SAE10W-30

engine oil; replace oil fill cap/dipstick.

4. Check engine oil level daily and add as needed.

NOTE: During the break-in period check the engine oil level often.

STEP 9: Add Gasoline to the Engine

1. Use only clean, fresh, regular unleaded fuel with a minimum 85 octane rating.

2. DO NOT mix oil with fuel.

3. Remove the fuel cap and slowly add fuel to the tank. DO NOT overfill allow

approximately ¼ inch of space for fuel expansion.

4. Screw on the fuel cap and wipe away any spilled fuel.

CAUTION

DO NOT attempt to crank or start the engine before it has been properly filled with the recommended

type and amount of oil. Damage to the log splitter as a result of failure to follow these instructions will

void your warranty.

After the assembling

finished, please keep the

elbow from the reversing

pipe in vertical position.