Use And Care Manual

- 8 -
STEP 4: Attach Engine
1. Install the engine place four polyurethane blocks (#71) and large flat washer Ø10 (#72)
between the mounting plate and engine.
2. Position the engine (#33) over the blocks and secure it to the mount plate put the hex bolt
M8x65 (#46) through the bottom of the plate (bolt should go through blocks, flat washer and
engine base). Place a flat washer Ø8 (#36),lock washer Ø8 (#32) and tighten the nylon lock
nut M8 (#31)
3. Attach the clear oil pipe (#53) to the bottom of the gear pump and secure with clamp (#51).
STEP 5: Attach Hydraulic Hose, Storage Tube, Log Table and Fender
1. Put O ring Ø11x2.5 (#19) on the gear pump outlet connector (#23), attach the hydraulic hose
(#16) to the gear pump outlet connector (#23).
2. Put O ring Ø17x2.5 (#68) on the external filter connector (#50), attach the hydraulic hose (#7)
to the connector (#50).
3. Remove the hex bolt M6x90 (#75), big flat washer Ø6 (#76) and nylon lock nut M6 (#77) from
the tow bar. Attach the storage tube (#74) using the hex bolt M6x90 (#75), big flat washer Ø6
(#76) and nylon lock nut M6 (#77).
4. Attach the log table (#64) to the beam using hex bolt M12x35 (#82), flat washer Ø12 (#62) and
nylon lock nut M12 (#13).
5. Attach the fenders (#85 & #86) to the oil tank using hex bolt M8x25 (#83), flat washer Ø8 (#36),
lock washer Ø8 (#32) and hex lock nut M8 (#31).
Note: Please put rubber washer (#84) between fenders and oil tank.