User's Manual

ManualsBrandsBryant ManualsDomestic Appliances95S

Owne r’s Manual

PLUS 95S -- MODEL 355CAV

DIRECT VENT 4--WAY MULTIPOISE

MODULATING CONDENSING GAS FURNACE

WITH PERFECT SENSET PERFECT HUMIDITYT

NOTE TO INSTALLER:

THIS MANUAL MUST BE LEFT WITH THE EQUIPMENT

USER.

USER: Please read all instructions in the manual and retain all

manuals for future reference.

FIRE OR EXPLOSION HAZARD

Failure to follow safety warnings exactly could result in

injury, death, or property damage.

Do not store or use gasoline or other flammable vapors and

liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

-- Do not try to light any appliance.

-- Do not touch any electrical switch; do not use any

phone in your building.

--Leave the building immediately.

-- Immediately call your gas supplier from a neighbor’s

phone. Follow the gas supplier’s instructions.

-- If you cannot reach your gas supplier, call the fire

department.

Installation and service must be performed by a qualified

installer, service agency or the gas supplier.

WARNING

CARBON MONOXIDE POISONING HAZARD

Failure to follow this warning could result in personal

injury and/or death.

Carbon Monoxide is invisible, odorless, and toxic! Bryant

Heating and Cooling Systems recommends a carbon

monoxide alarm in your home, even if you do not own a

gas appliance. Locate the carbon monoxide alarm in the

living area of your home and away from gas appliances and

doorways to attached garages. Follow the alarm

manufacturer’s instruction included with the alarm.

WARNING

CERTIFIED

As an ENERGY STAR® Partner,

Bryant Heating & Cooling

Systems has determined that

this product meets the ENERGY

ST AR® guidelines for energy

efficienc

A05085

Do not use this furnace if any part has been under water. A

flood--damaged furnace is extremely dangerous. Attempts to

use the furnace can result in fire or explosion. A qualified

service agency should be contacted to inspect the furnace

and to replace all gas controls, control system parts,

electrical parts that have been wet or the furnace if deemed

necessary.

Summary of content (14 pages)

PAGE 1
PLUS 95S - MODEL 355CAV DIRECT VENT 4--WAY MULTIPOISE MODULATING CONDENSING GAS FURNACE WITH PERFECT SENSET PERFECT HUMIDITYT Owner’s Manual NOTE TO INSTALLER: THIS MANUAL MUST BE LEFT WITH THE EQUIPMENT USER. USER: Please read all instructions in the manual and retain all manuals for future reference. ! CERTIFIED WARNING As an ENERGY STAR® Partner, Bryant Heating & Cooling Systems has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.
PAGE 2
TABLE OF CONTENTS WELCOME TO A NEW GENERATION OF COMFORT . . . 2 FURNACE COMPONENTS . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY CONSIDERATIONS . . . . . . . . . . . . . . . . . . . . . . . . 4 BEFORE STARTING YOUR FURNACE . . . . . . . . . . . . . . . . 4 STARTING AND SHUTTING DOWN YOUR FURNACE . . 5 Steps for Starting Your Furnace . . . . . . . . . . . . . . . . . . 5 Shutting Down Your Furnace . . . . . . . . . . . . . . . . . . . . 7 PERFORMING ROUTINE MAINTENANCE . . . . . . . . . . . .
PAGE 3
FURNACE COMPONENTS 17 2 3 12 4 1 18 5 6 11 5 15 14 13 16 7 9 19 8 10 A07609 Fig. 2 -- Model 355CAV Furnace 1. Combustion--air intake connection to ensure contaminant-free air (right or left side). 10. Heavy--duty blower. Circulates air across the heat exchangers to transfer heat into the home. 11. Everlastict Secondary condensing heat exchanger (inside). Wrings out more heat through condensation. Constructed with polypropylene--laminated steel to ensure durability. 2.
PAGE 4
SAFETY CONSIDERATIONS or when insulation is added. Some materials may be combustible. Recognize safety information. This is the safety--alert symbol S . When you see this symbol on the furnace and in instructions or manuals, be alert to the potential for personal injury. Understand the signal words: DANGER, WARNING, and CAUTION. DANGER identifies the most serious hazards which will result in severe personal injury or death. WARNING signifies hazards which could result in personal injury or death.
PAGE 5
STARTING AND SHUTTING DOWN YOUR FURNACE Instead of a continuously burning pilot flame which wastes valuable energy, your furnace uses an automatic, hot surface ignition system to light the burners each time the thermostat starts your furnace. Follow these important safeguards: S Never attempt to manually light the burners with a match or other source of flame. A08013 Fig. 7 -- Lowest Temperature Setting CL SE O A92319 Fig.
PAGE 6
A92359 Fig. 14 -- Turn On Electrical Supply OP A05087 EN Fig. 10 -- Remove Furnace Door A06189 Fig. 15 -- Open Valve 7. Replace main furnace door. (See Fig. 13.) 8. Turn ON the electrical supply to the furnace and wait 1 minute. (See Fig. 14.) 9. Open the external manual gas valve. (See Fig. 15.) 10. Set the room thermostat to a temperature slightly above the room temperature. This will automatically signal the furnace to start. 11. When the furnace receives the start signal, the inducer is started.
PAGE 7
your thermostat), and then return to ON. The blower will switch to the next higher speed. There are at least 3 speeds to choose from. If the blower is running on its highest speed, a request to change will direct the blower to return to its lowest speed. UNIT AND PROPERTY DAMAGE If you own an Evolution Control, simply push the “fan” button to change the fan speed. Failure to follow this caution may result in damage to the furnace and other property damage.
PAGE 8
will eventually lock out. It is recommended that the furnace air filter be checked every 3 or 4 weeks and cleaned if necessary. If installed with factory--specified disposable media filter, check or replace filter before each heating and cooling season. Replace disposable media filter at least once a year. The air filter is normally located in the blower compartment or in the factory--supplied filter cabinet attached to the side or bottom of the furnace casing.
PAGE 9
A93010 A93013 Fig. 23 -- Sliding Filter Retainer Sideways Fig. 26 -- Removing Air Filter A93011 A00227 Fig. 24 -- Slide Air Filter Out of Furnace Fig. 27 -- Slide Side Filter Out of Furnace A93012 A00228 Fig. 25 -- Removing Filter Retainer from Latch Fig. 28 -- Slide Bottom Filter Out of Furnace A93205 Fig.
PAGE 10
A06193 Fig. 32 -- Replace Bottom Filter Cabinet Door FURNACE AIR FILTER TABLE AIR FILTER LOCATED IN BLOWER COMPARTMENT FURNACE FILTER SIZE --- IN (mm) CASING FILTER WIDTH TYPE Side Return†* Bottom Return* IN (mm) A05088 Fig.
PAGE 11
! WARNING CARBON MONOXIDE POISONING HAZARD Failure to follow this warning could result in personal injury or death. If holes are found in the pipes or if any portion has become disconnected, toxic fumes can escape into your home. DO NOT OPERATE YOUR FURNACE. Call your dealer for service. Check the combustion--air intake and vent pipe on the outside of your home for blockage. A00223 Fig.
PAGE 12
2. Turn off electrical supply to the furnace. (See Fig. 17.) 3. Remove main furnace door. (See Fig. 19.) 4. Remove upper inducer housing drain connection cap. (See Fig. 35.) If you choose to leave your furnace on during extended absences do not set your thermostat lower than the limits shown in the Caution box above.
PAGE 13
A CHECK--UP CHECKLIST BEFORE YOU REQUEST A SERVICE CALL Your furnace represents an important investment in your family’s comfort and your home’s value. To keep it performing properly and to prevent future problems, have a trained service specialist give your furnace a professional check--up annually. The following checklist can be used as a guideline to proper service: S Inspect all flue gas passages, burners, heat exchangers, coupling box(es), and inducer assembly.
PAGE 14
NOTE TO EQUIPMENT OWNER: For your convenience, please record the model and serial numbers of your new equipment in the spaces provided. This information, along with the installation data and dealer contact information will be helpful should your system require maintenance or service.