Gas Heater User Manual

FEATURES AND BENEFITS

S Single cooling stage models are available from 3 -- 10 ton.

S Two cooling stage models are available from 7.5 -- 12.5 ton.

S SEER up to 13.0.

S EER’s up to 11.1.

S IEER’s up to 11.8.

S Up to 28% lighter than similar industry units. Lighter rooftops make easier replacement jobs.

S Utility connections are the same because 3 -- 12.5 ton units fit on existing Bryant rooftop curbs. This saves time and

money on replacement jobs.

S Standardized components and layout. Standardized components and controls make service and stocking parts easier.

S Scroll compressors on all units. This makes service, stocking parts, replacement, and troubleshooting easier.

S Field convertible airflow (3 -- 12.5 ton). Being able to convert a unit from vertical airflow to horizontal makes it easy to

overcome job site complications.

S Easy--adjust, belt--drive motor available. Bryant provides a factory solution for most points in the fan performance table.

S Provisions for bottom or side condensate drain.

S Capable of thru--the--base or thru--the--curb gas line routing.

S Single--point gas / electrical connection.

S Sloped, composite drain pan. Sloped, composite drain pan sheds water; and won’t rust.

S Standardized controls & control box layout. Standardized components & controls make stocking parts & service easier.

S Tool--less filter access door.

S Clean, easy to use control box.

S Color--coded wiring.

S Large, laminated wiring and power wiring drawings which are affixed to unit make troubleshooting easy.

S Single, central terminal board for test and wiring connections.

S Fast--access, handled, panels for easy access on normally accessed service panels.

S “No--strip” screw system guides screws into the panel & captures them tightly without stripping the screw, the panel, or

the unit.

S Exclusive, newly--design indoor refrigerant header for easier maintenance and replacement.

S Mechanical cooling (115_Fto40_For46_Cto4_C) standard on all models. Winter Start Kit allows cooling operation

downto25_F(--4_C) and Motor Master to --20_F(--29_C).

S High efficiency, gas heat with induced--draft flue exhaust design (3 -- 12.5 tons).

S Induce draft motor ensures no flue gas can escape into the indoor air stream.

S Bryant designed naturally draining heat exchanger, unlike positive pressure heat exchangers, do not need to be

periodically, manually drained. This saves labor and maintenance expense.

S 2--in (51mm) disposable filters on all units.

S Refrigerant filter--drier on each circuit.

S Each circuit is protected with a high and low pressure switch.

S Many factory--installed options ranging from air management economizers, 2 position dampers, plus convenience

outlets, disconnect switch and smoke detectors.

Standard Warranty: 10 yr. aluminized heat exchanger, 5 yr. compressor, 3 yr. Novation condenser coil, 1 yr. parts.

S Factory--installed Perfect Humidityr dehumidification system on 3 -- 12.5 ton models, includes MotorMaster I controller

for cooling operation down to --20_F(--29_C).

580J