Install Instructions

d Default = 2_F

6.3.1.3. Offsets

This option allows calibration (or deliberate miscalibration) of the temperature and

humidity sensors. These offsets are added to the actual temperature/humidity

values. When the correct offsets are made, touch SAVE.

S Outdoor temperature: Adjustable from --5 to 5_F(--3to3_C)

d Default = 0_F

S Humidity: Adjustable from --10 – 10%

d Default = 0%

6.3.1.4. Reset factory defaults

This option allows the installer to reset certain factory parameters. After the

selections are made, touch SAVE.

S Program Schedule: Reset back to pre--programmed time and temperature.

S User Settings: Reset user settings back to pre--programmed values.

S Install Settings: Reset installation settings back to pre--programmed values.

S Last 10 Faults: Reset the last 10 system faults under the Service menu.

6.3.1.5. Scheduling Enable

This option lets the installer allow programming features. After the selection is

made, touch SAVE.

S Scheduling: On or Off

d Default = On