MPS2 P O W E R S U P P LY OWNER’S MANUAL For use with preamp models BP26, BP26DA, BP26MC, BP26P & BP1.
IMPORTANT SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of un-insulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
INTRODUCTION Thank you for choosing this Bryston product. Bryston welcomes any suggestions or comments you may have about our products. We consider you, our customer, to be Bryston’s most important resource, and your opinion is very much appreciated. MPS2 POWER SUPPLY SPECIFICATIONS: Dimensions: Weight: 17” (or 19”) x 2.25” x 11” actual: 15.5 lb. (7.03Kg) shipping: 19.3 lb. (8.
REMOTE TRIGGER OUTput PINS A 12Vdc signal will be present on the OUT pins of the Remote Trigger Connector whenever the MPS2 is activated. This control signal can be used to operate other equipment with suitable remote control inputs, such as Bryston SST series power amps.
The MPS2 power supply can power several different Bryston products. Different products, however, may require different power supply interconnect cables, such as those shown shown below. It is important to use the correct power supply cable. WARNING! The connector terminals of main outputs 1, 2, 3 & 4 on the MPS2 power supply rear panel are HAZARDOUS LIVE and present a risk of electric shock. Use only preassembled power interconnect cables provided by Bryston for connection of these terminals.
REPLACING FUSES IN THE MPS2 POWER SUPPLY CAUTION: These service instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. All fuses are 5mm x 20mm, time lag type and are accessible only by removing the top cover. When replacing fuses, disconnect the power cord before opening the unit! Recommended replacement fuses: 100V~ models: T 2.
