User's Manual

C
L
O
S
E
O
P
E
N
C
L
O
S
E
O
P
E
N
C
L
O
S
E
O
P
E
N
12 3
45
C
L
O
S
E
O
P
E
N
Remove battery tab before use
NOTE:
To ensurt e optimum performance, do the following:
- Align both sensor and magnet as shown in the illustration (5a / 5b). Pay attention on the
alignment points.
- Ensure the distance between the sensor and the magnet is within 3 mm.
Ensure that both Speed sensor and Speed magnet are installed and aligned horizontally, t
not vertically.
On the initial usage, press the front button to activate the sensor and start pedaling. t
When the sensor detects the magnet, the LED blinks once to indicate the alignment is
Install Heart Rate Belt (Optional)
Electrodes
Strap
NOTE:
In cold weather, wear appropriate clothing to keep the heart rate belt warm.t
The belt should be worn directly on your body.t
Adjust the sensor position to the middle part of the body (wear it slightly below the
t
chest). The Bryton logo shown on the sensor should be facing upward. Tighten the elastic
If the sensor cannot be detected or the reading is abnormal, please warm up for about 5 t
minutes.
If the heart rate belt is not used for a period of time, remove the sensor from the heart t
rate belt.
ENGLISH
Appendix 35