User Manual

7Getting Started
Step 4: Acquire Satellite Signals
Once the Rider 320 is turned on, it will automatically search for satellite signals. It may
take 30 to 60 seconds to acquire signals. Please make sure you acquire the satellite signal
for the first time use.
The GPS signal icon (
/ )
appears when GPS is fixed.
• If the GPS signal is not fixed, an
icon appears on the screen.
• Please avoid the obstructed environments since they might affect the GPS reception.
Tunnels Inside rooms,
building, or
undergeound
Under water High-voltage
wires or
television towers
Construction
sites and heavy
traffic
NOTE: To improve the GPS accuracy, you can set 1 sec mode as your recording frequency
(page 17).
Step 5: Ride Your Bike with Rider 320
• Free ride:
In meter view, measurement starts and stops automatically in sync with the movement of
the bicycle.
• Start an exercise and record your data:
In meter view, press to start recording, press to pause recording and enter
the Menu. Then, choose to save your workout data.
NOTE: If you continue to proceed without pressing to record, Rider 320 would pop
up a reminder to ask you to record when motion of bike is detected. To set the
frequency of start reminder, please go to page 24.
Reboot Rider 320
To reboot the Rider 320, press two keys ( / ) at the same time.