Specifications

35
CCD-type image sensors to the PXA270 processor, depending on a specific CCD sensor’s
interface requirements.
The quick capture interface acquires data and control signals from the image sensor and
performs the appropriate data formatting prior to routing the data to memory using direct
memory access (DMA). A broad range of interface and signaling options provides direct
connection. The image sensor can provide raw data through a variety of parallel and serial
formats. For sensors that provide pre-processing capabilities, the quick capture interface
supports several formats for RGB and YCbCr color space. The interface supports the
“International Telecommunication Union Recommendation ITU-R BT.656-4”
(www.itu.int ) Start-of-Active-Video (SAV) and End-of-Active-Video (EAV) embedded
synchronization sequences for four- and eight-bit configurations.
For additional information, see Chapter 27: “Quick Capture Interface” in the PXA270
Reference Guide.
The quick capture interface signals are routed to the camera module connector (P36).
The camera module connector is designed to operate directly with the OPCOM
CM1314YMH-MO02 camera.
Connector P36, 24cont. FPC 0.5mm:
Pin Signal Name Pin Signal Name
1 CIF_DD0 13 NC
2 CIF_DD1 14 CIF_VDD_3V
3 CIF_DD4 15 CIF_VDD_1V8
4 CIF_DD3 16 CIF_LV
5 CIF_DD5 17 GND
6 CIF_DD2 18 CIF_FV
7 CIF_DD6 19 CAM_RST
8 CIF_PCLK 20 I2C_SCL
9 CIF_DD7 21 CIF_VDD_3V
10 GND 22 I2C_SDA
11 NC 23 GND
12 CIF_MCLK 24 GND