Service manual

Section - V Repair or Replacement BT3000 PLUS Rev. 0, Soft Ver. 8 Page 20 sur 22
5-5.2. 8-WIRE ANALOGUE RESISTIVE TOUCH-SCREEN
To remove the touch-screen, it is necessary to use a fine blade for lifting away the
glass-backing panel from the display. The touch-screen is secured to the LCD
panel with a very fine double-sided adhesive tape.
It is important that the glass-backing panel is precisely centered. Ensure that the
active area of the touch-screen matches the active area of the display. When
mounting the touch-screen, carefully observe the four angles marked on the
perimeter as a point of reference for facilitating the application. The new touch-
screen is already equipped with double-sided adhesive tape.
If necessary, replace the touch-screen driver. It is important to install the driver
found on the CD provided with the new touch-screen monitor. For application,
refer to Section XIV, Paragraph 14-2. Entitled "Computer Module Trouble-
Shooting".
Reading Station - Bottom View
Figure 5-23
Cable of
Reference
Channel