Service manual

Section - V Repair or Replacement BT3000 PLUS Rev. 0, Soft Ver. 8 Page 21 sur 22

Funnel Cap Opener

(Manutenzione Tappo Imbuto)

P/N 90-05036-01

Funnel

(Imbuto)

Serum Plate

(Piatto Sieri)

FUNNEL CAP OPENER

Figure 5-24

Grip Sleeve

(Manicotto)

P/N 662.1025

Cleaning Tool

(Specillo)

P/N 03254

Washing Piston

(Pistone)

P/N 20-05110-01

Washing Piston Removal & Cleaning

Washing Piston Kit P/N 662.0610

The washing piston (in Teflon) may have occluded holes. Turn off the analyzer prior to changing the

piston as follows:

1) Push the washing piston carriage fully upwards with the thumbs

2) Gently unscrew the washing piston from the plunger stem by inserting the supplied "Grip Sleeve" o

abrasive paper of fine mesh (to avoid slipping) and using light finger pressure clockwise.

3) Clean small holes on the side of the piston using the supplied "Cleaning Tool".

4) Fit the cleaned piston and finger tighten firmly by turning counterclockwise until properly seated

against thread shoulder of the plunger stem. Use "Grip Sleeve" to tighten

Figure 5-25