Specifications

BT-610 Manual Page 16 BT-610-9800 Rev A
4.4.6. Sample Timing
The following figures depict the sample timing sequence for both manual and auto
sampling modes. Figure 11 shows the timing for manual sample mode. Figure 12
shows the timing for auto sample mode.
Start
Time
Sample Time
Stop
Time
Figure 11 – Manual Mode Sample
Start
Time
Sample Time Hold Time Sample Time
Stop
Time
Figure 12 – Auto Mode Sample
5. Main Menu
The Main Menu is accessible by pressing the menu key on the Operate Screen. The
table below shows the Main Menu items. Press ▲ or ▼ to navigate to a menu item
then press Enter to display a screen where you can view or change item setting(s).
SAMPLE SETUP
SETTINGS
SERIAL
PRINTER
FAVORITES
SET SIZES
CALIBRATE FLOW
SET CLOCK
SET CONTRAST
ABOUT
Figure 13 – BT-610 Main Menu
Menu Item Description Press Enter to navigate to…
SAMPLE SETUP
View / change location number, auto / manual
mode, sample time and hold time.
Sample Setup Screen
SETTINGS
View / change volume (count units) and
temperature units ºC / ºF.
Settings Screen
SERIAL
View / change Serial Report type, Baud Rate
and serial mode.
Serial Screen
PRINTER View / change Printer enable setting Printer Screen
FAVORITES Set count alarm limits for 2 particle sizes Count Alarm Screen
SET SIZES Set particle sizes Set Sizes Screen
CALIBRATE FLOW Calibrate the sample flow rate Flow Screen