Operation Manual

If you need some help, call us on 0800 218 2182* or go to bt.com/producthelp
48
You can register up to five GAP
compliant handsets to your
BT1100 base to extend your
phone system without needing
to install telephone extension
sockets for each new phone.
If a handset becomes
un-registered it will need to be
registered to the base again.
Register handset? will be
displayed, press then
follow the instructions starting
from point 4 opposite.
You have 2 minutes to complete
the registration process.
If registration isn’t successful
the first time, please try again
in case the base registration
period ran out of time.
If there are already five
handsets registered to the
base, the registration will fail.
You must de-register another
handset before you can register
the new one, see page 49.
If you’ve bought a BT1100 multiple pack, any
additional handsets come pre-registered to the
base. However, if you purchase an additional
handset separately, you must register it to your
BT1100 base before it can be used.
Register an additional handset
1. Select Menu , scroll to Settings and press .
2. Press until Registration is displayed and
press .
3. Register Handset is displayed, press .
4. Press & hold find on base is displayed. Press and
hold the button on the base for 5 seconds.
The blue In use light on the base will start to flash.
5. Immediately, press on the handset. The
handset will display Registering handset to indicate
the base is in registration mode. If the system PIN
is not 0000 then you will be prompted to enter it,
then press .
6. Once registration is successful the handset will
show Handset x registered (with X being the
assigned handset number) and you will hear a
confirmation tone.
Using additional handsets