User's Manual

3
Magazine Adjustment
It is possible to slide the Magazine assem-
bly to your liking
1. Remove the 2 screws and metal plate
2. Slide the magazine assembly to new
location.
3. Reinstall the plate and screws, making
sure they are going into a body notch.
4. Tighten screws.
Loading Paintballs
1. Put on an eye protective device designed specifically for paintball and make sure
that anyone within range of the marker does the same.
2. Make sure the E-Grip is turned off and that a Barrel Blocking device is installed.
3. Load quality .68 caliber paintballs (leave some room for paintballs to move about
inside loader).
Rip-Clip™
Battery Installation
1. Remove the screw on top of battery door.
2. Install 4 x AA batteries following the polarity marking.
3. Reinstall the battery door screw. (Figure 1)
Rip-Clip Installation
1. Loosen up the spring screws. (Figure 2)
2. Clip on the BT Delta Elite™ between the 2 sight rails.
(Figure 3)
3. Make sure the feed holes are aligned. (Figure 4)
4. Tighten up the spring screws. (Figure 5)
Loader Installation
Insert the loader onto the
Rip-Clip as indicated.
Turn the loader Counter-
clockwise until it locked
firmly.
(Figures 6-8)
Activating the Rip-Clip™
Locate the power button on the rear control panel. To turn on, press the button. The
green LED comes on while the button is pressed; now release button. The green
LED will now flash again for one second, go off, then flash quickly 1, 2, or 3 times
indicating the speed it is currently set to. The motor will spin for a second and the
loader is now ready to use. Do NOT fire your marker until after the initial motor spin
has completed. Firing during this period can disrupt the auto-adjusting sound sensi-
tivity and cause the hopper not to work properly. The green LED will flash repeatedly
while the unit is on to show it is ready. If the LED flashing changes to red, then the
batteries are low and need to be replaced.
To turn off, press and hold until the loader gives a RED indication. Release the but-
ton and loader will power down to the OFF state.
Setting the Speed
1. When the Rip-Clip is first turned on, while the LED flashes for one long second,
press and hold the power button again during this flash.
2. When done properly, the LED will now change to red and you can release the but-
ton.
3. The LED will only stay red for about 15 seconds, then change back to its flashing
green sequence for regular operation if no buttons are pressed.
4. To set the speed during the red LED phase, push and release the button the num-
ber of times necessary based on what speed you desire.
5. Press once for normal slow speed, twice for faster normal speed, and three times
for fastest speed. Each time you press and release the button during this sequence,
the press of the button should last about one second.
6. If done too quickly, the board may not be set to the speed you desire. When done
correctly, the red LED will go off, then flash the same number of times the button
was pressed, indicating which speed it is now set to.
7. The motor will now spin up at the speed it is set to, it will stop, and now the speed
is set and the unit is ready to use.
Note: Always use good name brand batteries. Using other types of batteries will
affect the Rip Clips performance.
Figure 1
Figure 2 Figure 3 Figure 4
Figure 5
Figure 6 Figure 7 Figure 8
BT_DELTA_ELITE_Manual_1.qxp 11/29/07 5:07 PM Page 3