Operation Manual

Using the memory to store and
dial numbers
Putting the most regular or important numbers
you use in the memory means that you can dial
them using just two buttons.
Your Freestyle 520 Plus can store 10 phone
numbers, each up to 20 digits long.
Use the directory label on the inside of the
handset to keep a record of the numbers you
have stored in the memory.
To store numbers in the memory
• Do not lift the handset when storing or
removing a number from the memory.
• Press the
MEMORY button and the display
will show
MEM.
• Press a number button between
0 and 9
under which you want to store the
memorised number. The display will show
the number you have pressed.
• Dial the phone number you want memorised.
• Press the
MEMORY button again to store the
number. You will hear a beep which confirms
that the number has been stored.
To store up to nine other numbers, just repeat
these steps. Remember to use a different
number between
0 and 9 each time you store a
phone number.
Memory
Memory
23
How to use your
Freestyle 520 Plus base unit
To dial numbers stored in the memory
• Pick up the handset or press the MONITOR
button.
• Press the
MEMORY button. The display will
show
MEM.
• Press the number between
0 and 9 under
which you have stored the number you want.
• The phone number will be displayed and
dialled automatically.
• If you pressed the
MONITOR button, you must
pick up the handset when your call is answered.
• End the call as normal.
To put a pause in the memory
For such services as home banking,
you may need to use the PAUSE
function. Storing this in the memory is simple.
Start programming in your number as shown.
Where you need a pause, press the PAUSE button.
The display will show P. Continue the rest of the
memory programme as normal.
Pause
The cordless handset and base unit use separate
memories which operate independently of each
other. This means that you can store one set of
phone numbers in the base unit and another in
the cordless handset.
A phone number stored in the memory of the
cordless handset is not automatically stored in the
base unit. You must put the number into each
memory separately.
0- 9
Memory
Memory
0- 9