Dual Digital Drive COMBO 5216IA User’s Manual
CLASS 1 LASER PRODUCT APPAREIL A LASER DE CLASSE 1 LASER KLASSE 1 LUOKAN 1 LASERLAITE PRODUIT LASER CATEGORIE 1 DANGER VORSICHT ATTENTION INVISIBLE LASER RADIATION WHEN OPEN AVOID DIRECT EXPOSURE TO BEAM INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT DEM STRAHL AUSSETSEN RADIATION DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE. EVITER TOUTE EXPOSITION AUX RAYONS.
FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. FCC Warning Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Table of Contents INTRODUCTION SYSTEM REQUIREMENTS PACKAGE CONTENTS INSTALLATION 1 2 2 3 HOST INTERFACE CONNECTIONS HARDWARE INSTALLATION DRIVER INSTALLATION SOFTWARE INSTALLATION DVD REGION CODE 3 4 6 9 11 OPERATION & CONNECTION 13 FRONT PANEL REAR VIEW TECHNICAL DATA 13 15 17
Dual Digital Drive INTRODUCTION Welcome to a multimedia world of CD-ReWritable technology, DVD-ROM capabilities and, memory card compatibility! This compact and high-performance COMBO 5216IA frees up precious bay space and presents you as an IDE Combo (CD-RW+DVD ROM) Drive and a USB-connected card reader. It reads CDs of all types at maximum 52X speed, and DVD-ROMs at maximum 16X speed. For the writing ability, it writes to CD-Rs at up to 52X speed, and to CD-RWs at up to 24X speed.
♦ Dual Digital Drive ♦ Smooth DVD playback System Requirements For IBM compatible PCs, the system requirements recommended are as follows: ♦ Pentium II, Celeron 400MHz or above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.
Dual Digital Drive INSTALLATION Host Interface Connections Most current mainboard models have two IDE ports (primary and secondary), which can connect two IDE cables. Two IDE cables allow you to connect up to four devices, but it is recommended that you separate IDE ports for your hard drive and your Dual Digital Combo Drive. This will ensure that your hard drive’s performance and speed won’t be affected by having the drive on the same cable.
Dual Digital Drive CSEL MASTER SLAVE JUMPER Improper or conflicting setting will cause the unit not detected by your system. Hardware Installation 1. Turn off the power to your computer system. 2. Disconnect the power cord and all cables from the back of your computer, and then remove the cover of the computer. 3. Insert the drive into one of the vacant 5.25" drive bays and secure it to your PC with all four mounting screws. 4.
Dual Digital Drive 5. If you have a sound card that can be connected to the drive, you can also connect the drive (as Audio-Out) and the sound card (as Audio-in) with a 4-pin audio cable. If your mainboad is integrated with built-in sound system, plug the 4-pin audio cable into the CD-IN connector on the mainboard as Audio-in. 6. Connect the USB cable at the back of the drive to the USB header on the computer’s mainboard. The red wire of the cable needs to be plugged into Pin 1 on the board.
Dual Digital Drive Driver Installation For the Combo Drive For the Combo Drive itself, it’s an IDE device supporting Plug & Play and Windows 98SE/ME/2000/XP can automatically detect the drive and load the appropriate driver. For the Card Reader Windows 98SE/2000 If you are using Window 98SE or 2000, please install the provided driver. 6 1. Insert the application disc. 2. Select:\Card Reader Driver 3. Click “setup.
Dual Digital Drive Click “OK” if you have already had USB cable connected (Refer to Hardware Installation, Step 6.
Dual Digital Drive Make sure to restart your computer. Windows ME/XP Since Windows ME and XP already have USB Mass Storage support, the card reader can be detected and work fine without installing driver. However, we recommend that you install the provided driver to have more explicit operation status of the card reader, as described below. For Windows XP users, please upgrade to Service Pack 1.
Dual Digital Drive After the driver installation, 4 extra icons with different card type indicated will show in Device Manager/My computer. And then you can use each slot of the card reader for file archiving/recording. While the card reader is reading data of memory cards, the icon for the card accessed will light up and the LED beside the card slot on the front panel will flash Green.
Dual Digital Drive resolution 720 x 480 video playback. You can enjoy the wide range of educational and entertaining CD/DVD titles with sound and visual effect of theater quality. Windows Environment 1. Insert the application CD and the installation program will run automatically. Then follow the on-screen procedures. Or 2. 10 Run:\setup.exe on the application CD.
Dual Digital Drive DVD Region Code Region Playback Control Management All DVD Video Playback systems have “Region Playback Control” management (RPC) which is required by Hollywood movie industry and defined by DVD Forum. This includes DVD-Video players and PC systems with DVD-Video capability. You can only play DVD-Video discs with the same region code as your DVD-Video Playback system.
Dual Digital Drive About This Dual Digital Combo Drive This drive is also a RPC2 DVD-ROM drive and according to DVD-Forum, PC chip must be designed into DVD-ROM drives to record how many times a user has changed the region code. The first region code will depend on the DVD title you play and you are allowed to modify the region code 5 times (including the initial one).
Dual Digital Drive OPERATION & CONNECTION Front Panel 2 5 1 11 7 8 3 4 6 9 10 1. Headphone Jack By plugging in the stereo mini jack here, you can listen to an audio disc directly playing from the drive with headphones. 2. Headphone Volume Control This rotary knob adjusts the audio output level. Turn the wheel to the right/left for the volume control of your headphone. 3. Play/Skip button Press this button to play tracks or skip to next track during the playing state.
Dual Digital Drive 4. Close/Eject button This button opens and closes the disc tray. If the tray is closed, pressing the button will eject it. If the drive is playing audio, pressing this button will stop it. 5. Led Indicator (Combo Drive) Flashes “green” while verifying or reading a CD/DVD. Flashes “red” while writing data. While the tray goes in/out, the indicator lights green and it’s off when the drive is ready. 6.
Dual Digital Drive Rear View 3 4 5 6 1. Digital Audio Output Connector If your sound card has a digital audio IEC958 format connector, you can connect it to this digital audio output connector with a 2-pin audio cable. 2. Analog Audio Output Connector This connector allows you to connect the drive to your sound card with a 4-pin audio cable. 3. Device Configuration Jumper Set the jumper to Master, Slave or Cable Select according to your system configuration. 4.
Dual Digital Drive 5. Power Supply Connector By plugging the computer’s power supply cable here, you can connect the drive and your computer system. 6. USB Cable Connect the USB cable to the USB connector on the mainboard. The red wire of the cable needs to plug into Pin 1 on the board.
Dual Digital Drive TECHNICAL DATA Interface Combo Drive: IDE Card Reader: USB 1.1 Form factor 5.
Dual Digital Drive Disc Format Supported Write Read CD-DA CD-ROM CD-ROM XA CD-EXTRA Video CD Photo CD CD-I CD-TEXT DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD+RW, DVD-RW Data buffer 2MB Disc loading Tray (motorised), Dust Sealed Audio output level Line out = 0.6 ± 10%Vrms Headphone out = 0.6± 10%Vrms Power 5 VDC & 12VDC Card Reader power directly from computer power supply through USB connection Dimensions Height Width Depth Weight 18 41.8 ± 0.2 mm 148.8 ± 0.2 mm 193.4 ± 0.
Dual Digital Drive Environment Combo Drive Temperature Operating 5°C to 45°C Non-operating -20°C to 60°C Humidity Operating 8% ~ 80%RH Non-operating 5% ~ 95%RH Card Reader Temperature Operating 0°C to 40°C Non-operating -20°C to 45°C Humidity Operating 0% ~ 90%RH Non-operating 0% ~ 95%RH Disc Disc Size 80mm and 120mm discs Disc Data Capacity DVD-ROM: Single layer – 4.7GB Dual layer – 8.
3100551980 Version 1.0 Oct.
