User's Manual

149
The Master sensor has a round black button at its top. When performing a test, this button is pressed at
the start and end of a test range. The difference between the two readings is calculated and entered into
the ODES diagnostic software system. The Inclinometers will not measure accurately if the hinges are at
opposite ends as in this picture. As well the Inclinometers cannot operate in the coronal plane of
movement.
The BTE Dual Inclinometers can also be used as a Small Goniometer when they are attached to each
other. The Dual Inclinometers can be joined to each other as demonstrated in the figure below.
The Master and Remote sensors attach at their bottom corners,
where they form right angles.
When attached, the Dual Inclinometers can be used as a Small
Goniometer to measure finger and thumb range of motion.
To start measuring using the Inclinometers click on the button on the Master or on the foot pedal. To stop
taking the measurement click once again.
The Master and Remote sensors of the Dual Inclinometers have internal magnets. As a
result, it is strongly suggested that these are NOT placed on computer hard drives, since
doin
g
so ma
y
result in erasure of data files!